Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
cloudproviders:amazon_aws [2016/11/07 12:05] – [Launch a new instance] borja | cloudproviders:amazon_aws [2016/11/07 12:26] (current) – [Finalize your installation] borja | ||
---|---|---|---|
Line 27: | Line 27: | ||
{{: | {{: | ||
+ | |||
+ | ==== Launch next steps ==== | ||
+ | |||
+ | {{: | ||
+ | |||
+ | You can skip the fine tune option to directly launch the instance, so you will configure your Security group here are later from the Dashboard : | ||
+ | |||
+ | * Open TCP / SSH port : 22 | ||
+ | * Open TCP / HTTP port : 80 | ||
+ | * Open UDP / IAX port : 4569 | ||
+ | |||
+ | The IAX port is used to allows placing calls from : | ||
+ | * a IAX Soft Phone ([[installation_guide: | ||
+ | * the test numbers ([[installation_guide: | ||
+ | |||
+ | If you choice to connect a Voip account to a Telecom provider, you will need to open : | ||
+ | |||
+ | * Open UDP / SIP port : 5060 (take care about the SIP attacks) | ||
+ | * Open UDP / RTP ports : 10000 to 20000 | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Validate your instance configuration. | ||
+ | |||
+ | You got the Launch status : Instance launching... | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | ==== Edit Security groups (open/close TCP/UDP ports) ==== | ||
+ | |||
+ | {{: | ||
+ | |||
+ | |||
+ | ==== Finalize your installation ==== | ||
+ | |||
+ | To finish your installation you need to connect for the first time to your Web Interface to set your administration password. | ||
+ | For security reasons, you need do to it just after the launch. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | You will see the main status panel : | ||
+ | |||
+ | {{: | ||
+ | |||
==== Test your installation ==== | ==== Test your installation ==== |