Differences

This shows you the differences between two versions of the page.

--- cloudproviders:amazon_aws [2016/11/07 12:05] – [Launch a new instance] borja
+++ cloudproviders:amazon_aws [2016/11/07 12:26] – [Finalize your installation] borja
@@ Line 27: / Line 27: @@
 {{:cloudproviders:aws_community_amis_voxibot.png?nolink&800|}}
+==== Launch next steps ====
+{{:cloudproviders:aws_step_2_choose_instance_type.png?nolink&800|}}
+You can skip the fine tune option to directly launch the instance, so you will configure your Security group here are later from the Dashboard :
+  * Open TCP / SSH port : 22
+  * Open TCP / HTTP port : 80
+  * Open UDP / IAX port : 4569
+The IAX port is used to allows placing calls from :
+  * a IAX Soft Phone ([[installation_guide:softphone:start|Soft Phone connection]])
+  * the test numbers ([[installation_guide:test:start|Call the test service]])
+If you choice to connect a Voip account to a Telecom provider, you will need to open :
+  * Open UDP / SIP port : 5060 (take care about the SIP attacks)
+  * Open UDP / RTP ports : 10000 to 20000
+{{:cloudproviders:aws_step_7_review_instance_launch.png?nolink&800|}}
+Validate your instance configuration.
+You got the Launch status : Instance launching...
+{{:cloudproviders:aws_lunch_status.png?nolink&800|}}
+{{:cloudproviders:aws_instance_view.png?nolink&800|}}
+==== Edit Security groups (open/close TCP/UDP ports) ====
+{{:cloudproviders:aws_edit_inbound_rules.png?nolink&800|}}
+==== Finalize your installation ====
+To finish your installation you need to connect for the first time to your Web Interface to set your administration password.
+For security reasons, you need do to it just after the launch.
+{{:cloudproviders:voximal_set_admin_password.png?nolink&800|}}
+You will see the main status panel :
+{{:installation_guide:configuration:voximal_system_status.png?nolink|}}
 ==== Test your installation ====